#4 Case Holder
Complete Lathe kit for 17 Caliber
#H Case Holder
#4 Case Holder
Neck Turning Lathe Kit includes:
Lathe base-tail stock assembly-L bracket, Neck Turning Tool, Cutter,
Case Holder &Driver, Expander Die Body, Turning Arbor and Expander Mandrel.
Kits are available for both Stainless Steel and Titanium Nitride $295.99 - $315.99
This is the first in the series of 21st Century Shooting Case Preparation. A modular system, all parts interchange. So if you have our Neck Turning Tool or Bracket everything will fit.
The floating design of our neck turner and case driver allows the case mouth (bore) to run on the arbor absolutely concentric. Therefore allowing O.D. to be turned concentric with I.D.
The tail-stock creates a horizontal inline support for the base of the case. Also allows the operator to keep both hands on the power screw driver or drill. This makes it very easy to control feed rate of the cutting operation, generating a very fine turned finish.
Case holder drivers are designed to be the most gentle driver, yet providing an adequate hold.
DOES NOT DRIVE OFF THE PRIMER POCKET - NO PRIMER POCKET OR CASE DAMAGE.
There are counter sunk mounting holes in the base plate for mounting.
Driver shaft is hexed to use power screw driver or drill.
Tail-stock base is adjustable to accommodate cases from 17 Fireball to a .416 Rigby.
I use a Hitachi 12 volt cordless driver drill. DS100FL. Light weight 2.2lbs, 2 speed with a li-ion battery.
One of our representatives will be happy to contact you within 24 hours. For urgent needs call us at: +1.260-273-9909
Order anytime online. 7 days a week. 24 hour a day!